potatobro@lemmy.blahaj.zone to 3DPrinting@lemmy.worldEnglish · 1 day agoStay safe folkslemmy.blahaj.zoneimagemessage-square58linkfedilinkarrow-up1659arrow-down16
arrow-up1653arrow-down1imageStay safe folkslemmy.blahaj.zonepotatobro@lemmy.blahaj.zone to 3DPrinting@lemmy.worldEnglish · 1 day agomessage-square58linkfedilink
minus-squareTurboWafflz@lemmy.worldlinkfedilinkEnglisharrow-up21·1 day agoFinally got around to checking mine this morning, luckily I don’t have the component
minus-squareStatick@feddit.onlinelinkfedilinkEnglisharrow-up3·1 day agoAre there instructions on what to check? I have an X1C from May 2023. Would that be affected?
minus-squareTurboWafflz@lemmy.worldlinkfedilinkEnglisharrow-up10·1 day agoI think it only affects the A1. On the a1, board 2 is the safe one. The circular black thermistor on the left side is the component that overheats
minus-squarewashbasin@sh.itjust.workslinkfedilinkEnglisharrow-up1·22 hours agoI’m having a hard time finding documentation on where to actually locate this board. Is it underneath the heat bed?
minus-squareTurboWafflz@lemmy.worldlinkfedilinkEnglisharrow-up2·22 hours agothis is what I followed to get to it https://wiki.bambulab.com/en/a1/maintenance/ac-board-replacement
minus-squarewashbasin@sh.itjust.workslinkfedilinkEnglisharrow-up1·12 hours agoThank you! I was struggling.
minus-squareStatick@feddit.onlinelinkfedilinkEnglisharrow-up2·1 day agoThank you for the quick reply!
Finally got around to checking mine this morning, luckily I don’t have the component
Are there instructions on what to check? I have an X1C from May 2023. Would that be affected?
I think it only affects the A1. On the a1, board 2 is the safe one. The circular black thermistor on the left side is the component that overheats
I’m having a hard time finding documentation on where to actually locate this board. Is it underneath the heat bed?
this is what I followed to get to it https://wiki.bambulab.com/en/a1/maintenance/ac-board-replacement
Thank you! I was struggling.
Thank you for the quick reply!