I am looking to purchase a 3D printer as a hobbyist, not for any commercial use. I have limited options with local 3D printers but that’s good as they’re mostly cheaper low end printers so I can look at them thoroughly.
When I’m comparing the different 3D printers I’m mainly looking at the following: Cost, nozzle diameter, layer height, volume, and viable filaments.
My question is, is there anything else I’m missing? Are there important things I should be considering or avoiding?
Different printers have different resolutions but for my purposes it looks like they’re all highly accurate and way past what I need. Not worried about speed either. They all mention bed and nozzle temperatures but I assume they are all within the necessary range for the filaments they allow right? So does it matter?
Also, any advice for maintenance? How to make it last as long as possible any mistakes I should be wary of. Thanks.
Check that it works with Klipper!
The convenience and control Klipper provides is phenomenal. You don’t have to use it if it turns out you dont like it, but I feel like ruling it out as an option now would be a shame.
I would also point out that you should not be put off by the “official” supported printers list for Klipper, a bit of Googling will often turn up some mini projects where people are actively working on supporting the printer with Klipper before the main project gets round to adding official support.