

Until Lemmy can offer me the active specialized subs I use reddit for, it’s pretty hard to drop it completely.
Until Lemmy can offer me the active specialized subs I use reddit for, it’s pretty hard to drop it completely.
They stated 250C was for annealing to final product. That’s a temperature any bog standard toaster oven or kitchen oven can do. Sadly, they said nothing I saw about actual extrusion temps.
With out Bezo’s name recognition very, very few would have heard about Slate and their little pickup/SUV. That’s a level of advertisement that money simply can’t buy as a startup. We certainly wouldn’t be talking about them without Bezos’ name being attached to them. And they certainly wouldn’t have access to the investors and financial doors his name can easily open.
I have. Then I realize Slate doesn’t get a chance to change vehicular design without him.
It’s a lifestyle thing and it mostly harmless. Best not to question it.
Transparency: I have owned and still do own a Jeep. I like my 2015 Patriot.
The only ads I see are on a local sports podcast. The advertisers are all local businesses. From restaurants to local credit unions. And those I’m fine with.
FDM printing ABS/ASA is far easier and safer than resin printing since most CoreXY printers are enclosed these days. A simple fan and ether venting to the outside world or through activated charcoal air filters is a relatively simple procedure. Printers with all of that filtration are easily purchased these days. Even vapor smoothing can be done outdoors if it’s warm enough.
They understand just how hard it would be to comply. And that’s the point. Make it hard enough to meet the requirements to not make worth a business’ while to comply. And the politicians can say “We didn’t ban PornHub. They blocked you from access.”
It’s a common tool both the left and right use to control behaviors. Governments around the world do this all the time.
Their Plus 4 printer is supposed to have multi material box -a la AMS- some time this year. But there hasn’t been much said about it since the release of the Plus 4 model.
The only other one I know of, outside of a dual exturder Voron, is the Qidi I-Fast IDEX printer. It’s expensive, somewhat over $1000, but it has a lot of goodies too. 350C extruder, heat chamber, and a decent sized build volume to print just about any engineering filament.
I got my A1 mini just a month or two before this current unpleasantness, so I was taken unaware. But since I’ve never been interested in using much of the Bambu software ecosystem, switching to LAN mode a month ago has been no big deal for me because I was leaning that direction anyway. And my current firmware version, 1.04 works well so no need to up grade. Nor is Makers World all that important to me.
But there are so many users that just don’t care and will swallow what ever dreck Bambu feeds them.
Roll back the firmware to a version that worked. You still can do that.
The problem with new PEI sheets everyone sells, is that they make the PEI so thin that it wears out so fast. It’s like when they go to cut a slice off the PEI tree, they damn near miss the whole tree. And the popularity of textured sheets doesn’t help either.
I have a smooth PEI sheet that came with my Prusa Mk3s 6 years ago. It has 1000’s of hours of print times on it. After about 4 years of heavy use, it just wasn’t much good anymore. And I didn’t feel like buying a new sheet, so I took the chance and very lightly hit with some 1000grit wet/dry sandpaper to renew the surface. It now holds better than when it was new. And I can probably sand it again if it ever needs it. But new PEI plates aren’t coated half as thick either. So my Bambu plates will have to be replaced at some point.