• 1 Post
  • 98 Comments
Joined 1 month ago
cake
Cake day: June 5th, 2025

help-circle






  • I disagree with it being a first layer issue otherwise it would be failing much earlier not 80% of the way through the print. If the first layer being too thick were the issue, it would also be visible or colliding with every layer below this one too and those layers appear to be fine.

    Do you have other filament to test with? That would help isolate the issue to either the filament or the printer. It could be the Z axis screws need lubrication especially if you notice this issue happening at around the same height.

    How many hours are on your nozzle? Ive had to swap out my nozzle on my X1C after having similar issues and they went away. Even the hardened steel nozzles wear out and allow too much flow through them which leaves extra plastic on the print that can lead to collisions.












  • One of my earliest memories was being into Britney Spears. I was young, 10 or so. Dad was never home and I learned to like my own music on my own time without him, and I liked her music. My memory is that I was listening to it in the car, my CD of hers, and then I remember mom and dad arguing, and I don’t remember ever seeing that CD again.

    Its so funny to see all those guys, who called groups like Nsync and BSB “gay” back in middle school in the '90s, lose their fucking minds and start singing and dancing along when something like “Bye Bye Bye” comes on the jukebox at the bar.

    To be honest, I hated boy bands back then too but there’s definitely some nostalgia hearing them today.