Mobile app, web app, firmware, bootloader…

Unfortunately no support for Ecovacs.

They could be, but 2M new Brazilian users after Twitter’s block there actually seems quite low and definitely credible.

On iOS I’ve been using Vinegar - Tube Cleaner by developer And a Dinosaur. It doesn’t replace YouTube as a whole - only the video player. Better interface, no ads.

Ah NFS… It’s so good when it works! When it doesn’t though, figuring out why is like trying to navigate someone else’s house in pitch dark.

FUD wars on Free and Open Source Software, shady deals with companies and governments to make them dependent on MS software and solutions, holding the web hostage to IE “standards”, …

Could you provide a source for this claim? Not doubting you but I haven’t seen it.

That’s great! I’ll give it a go again soon.

Whilst this is fair criticism, I was responding to complaints about the UX in other CADs.

Yeah I’ve been meaning to try FreeCAD in anger but every time I try it out I find it clumsy, awkward and limited. I’m hoping the new organisation will allow them to get more funding, I’d really love an actually good open source CAD.

Thanks for the detailed report! 💪

That’s on the free license. Fusion360, to which this thread is offering an alternative, has the same limitation.

https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/Do-I-qualify-for-free-use-of-Fusion-360.html

I found Onshape to be quite nice. It was relatively easy to translate skills from Fusion to it after a few YouTube videos.

I’ve been using glauth + Authelia for a couple years with no issues and almost zero maintenance.

https://github.com/glauth/glauth https://www.authelia.com/

Yes, absolutely. Ideally there would be an automated check that runs periodically and alerts if things don’t work as expected.

Monitoring if the backup task succeeded is important but that’s tue easy part of ensuring it works.

A backup is only working if it can be restored. If you don’t test that you can restore it in case of disaster, you don’t really know if it’s working.

I guess it depends on where you are. Where I am the air is a lot less humid than in other places, and I have the opposite effect. I put the filament roll in the dryer and start printing. As time passes, like the filament gets dryer and stringing reduces.

Ah got it. I didn’t know there was a free tier!

How do you use ChatGPT anonymously? It requires a valid login linked to a payment method. It doesn’t get any less anonymous than that.

I thought it was pretty common knowledge that these dryers lack airflow. There are tons of printable wedges in printables.com and thingiverse.com to keep the lid open.

This alone speeds up drying massively. Adding a small fan to the opening might be even better but I never found it necessary.