I mean, it is an option technically. If we all just went extinct we wouldn’t have any more racists.

I honestly never realized it’s a musical. I knew there was music but it never felt like a musical to me.

I just woke up and read “Hawai’i gets $9” and stopped very confused for a moment.

Ah, i can’t find the thing i read now so I’ll assume you’re right.

Imagine a password about 80000 characters long.

If i was a cat I’d knead a blåhaj

I thought the same thing for awhile!

It might break the roof. Those straps are nearly as wide as that truck’s brake lights, i don’t see them snapping so easily.

Wow, this is an incredible guide thanks for showing me

I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.

I have never bought an ender. I just happen to have one :P

Ah, thank you for the advice and the link!

The falling prints i think have issues in the same spots, there are relatively small patches around the print surface that don’t print very well, though they don’t seem to correspond to the bed leveling screws or anything. Now that i say that I’ll have to check that I’m using the mesh level correctly when i get home.

I’m still using a Bowden type extruder. The extruder itself is a generic aluminum one. My filament is run out of a sunlu dryer by the side of the machine.

I think i actually raised the jerk at one point to reduce the radius on corners, so i can bring that back down again and experiment with acceleration.

I have a glass bed and I’m using the tramming function with the mriscoc firmware to give me depth readings for each of the four screws, and I usually reign them in to about 0.04mm range. Parts close to each other tend to have similar but not the same results, and i think the patches are too small to be from bed leveling, usually only a couple centimeters.

I can redo esteps, i can see what you mean about the overextrusion. I only set my esteps to the number recommended by the manufacturer of my extruder, but i haven’t measured it myself yet, maybe that’s a bit silly of me. Though if that’s the problem then I’m still curious why it’s different in different areas.

I can check out acceleration too, i looked up what acceleration and jerk meant at one point but it didn’t make much sense to me at the time.

Yeah yeah you know what i mean

Gen z here. I was not around in the 80’s or 90’s, but everything people describe as being from the 90’s and some stuff from the 80’s was just my life in the mid 2000’s. I definitely know what pagers are. Like hell, we had a stack of floppy discs at home and my first computer had a floppy disc reader. I used to play duck hunt on my dad’s nes and super Mario Land on my own Gameboy. That stuff doesn’t just disappear at the turn of the decade.

Ok, but the providers will not offer such a service. I’d gladly take 2fa using biometrics and a password/passkey with my username working as it always has.

I had fun with that for a few minutes

Common piracy W

They have absolutely thought through what they want in terms of features and the features they described absolutely require machine learning as it stands today. I cannot think of any other methods to remove advertisements from objects in a live video feed like the pitcher mound example op provides.