• 0 Posts
  • 13 Comments
Joined 2 years ago
cake
Cake day: June 12th, 2023

help-circle








  • My best guess would be that you have some petg left in the nozzle that for whatever reason isn’t being melted and pushed out, what you could try is doing a cold pull

    If you haven’t done it before, you basically heat up the hotend, feed in some plastic, then you turn off the heat and let it cool down until the plastic is partially hardened, then you yank on the filament

    If everything goes right, the plastic down in the nozzle will be yanked out, and pull with it any impurities, leaving the nozzle clean and unclogged

    Alternatively buy a new nozzle that you only use for PLA, i have heard a lot of people having issues like this when switching back and forth with the same nozzle



  • Ignotum@lemmy.worldtoDad Jokes@lemmy.worldThree logicians walk into a bar
    link
    fedilink
    English
    arrow-up
    22
    arrow-down
    3
    ·
    1 year ago

    OCs point was that if the first person hadn’t made up their mind yet, that would also cause them to say “i don’t know”, but the two following logicians seem to assume that the first person said “i don’t know” because they wanted it but didn’t know if the other two did

    It’s a false dichotomy and faulty logic if you look too closely

    But it’s a pretty funny joke