It’s more like 3 really wide pixels.

I haven’t had the courage to run executable code from P2P networks since the early 2000s. Even then it was probably a bad idea.

You can even have your printer run shell commands

I briefly considered using Klipper to make a clock that prints 1 layer per minute, but gave up after realizing it’d be unreadable after the first hour:

When my Ender 3 S1 (not plus) had bed leveling issues, the problem was caused by backlash on the Z axis. It’s important that the Z axis be just loose enough that downward motion is driven by gravity. If instead the Z screws have to “pull down” on the gantry, then the height will be too sloppy for ABL to make fine adjustments.

You are 10% hydrogen already.

It’s not clear to me what you’re trying to do. Are you looking for Dual4010_Satsana_by_Gorroth.stl but in Fusion360 format?

The original model has some .step files.

When I load your model and enable “Preferences > Features > vertex-object-renderers”, the Preview pan/zoom/rotate goes much faster, and “vertex-object-renderers-prealloc” seems to reduce the Preview computation time.

Between 2017 and today, it was a mostly-blank page with the letter “x”: https://web.archive.org/web/20230722020649/http://x.com/

independent X and Y accels

This requires patching Klipper, right? I don’t think I want to bother with maintaining a fork.

Though I designed a Z axis brace and plan to add some X/Y linear rails.

Android still doesn’t support DHCPv6 and will be left without a valid address.

RFC 7934 explains their reasoning, though it’s not exactly an ironclad argument.

BL-5C is becoming a de facto standard size for random electronics, but it’s too small for a smartphone.

It is straightforward to run an isolated network with TCP/IP, DNS, and web servers. The hard part would be dealing with software that complains/fails if you’re not using HTTPS.

In general, you would want an offline copy of the entire software stack (e.g. a Gentoo Linux mirror) so you can patch whatever problems you encounter.

It is possible to smooth PLA using ethyl acetate, but I don’t know if that’s good enough for food safety, plus you have to remove the ethyl acetate itself.

PLA won’t survive in a dishwasher. PETG might, but there are no reasonable solvents for smoothing PETG.

Maybe it’d be best to print a mold in PLA, smooth with ethyl acetate, clean thoroughly, and then pour silicone into the mold.

Benchy was not designed to float. An STL file only defines the external geometry, but if you print it with default slicer settings, the density will be relatively constant throughout, and the resulting center of gravity is too high and too far forward to function as a boat.

In order to make it float, I put more mass at the bottom/rear and less at the top.